allburger
Enlightened
I have my KX2 head open and I can see the LED, how do i get to the driver to swap it?
HOW TO?? KX2 driver swap
- Thread starter allburger
- Start date
Help Support Candle Power Flashlight Forum
Blindasabat
Flashlight Enthusiast
You have to open up the lower half to access the driver.
Heat it up again like you (most likely) had to do to the bezel.
Hold the lower part and firmly twist the black inner part with pliers squeezed into the two semicircle vertical slots on the ID where the LED is.
The black threaded part should unscrew from the bottom. then you can acess the driver.
Heat it up again like you (most likely) had to do to the bezel.
Hold the lower part and firmly twist the black inner part with pliers squeezed into the two semicircle vertical slots on the ID where the LED is.
The black threaded part should unscrew from the bottom. then you can acess the driver.
DM51
Flashaholic
Moving this to H&M...
foxtrot824
Enlightened
Take a look here I opened up and E1b head for modding and it is similar to the KX2 inside.
Last edited:
allburger
Enlightened
I appreciate it. Thank you.
Anyone have any advice on how to open it. Heat, rubber for grip, etc...??
Anyone have any advice on how to open it. Heat, rubber for grip, etc...??
