Iam doing a one time prie drop to $300, sure wont mind keeping this one.
No Fetie switch, just stock SF tailcap.This is directly from the post that I bought this drop in from, I got the alum 4k 1665lumen three mode low/med/high unit.I paid $190 plus shipping for it directly from the maker. let me know if you have any other questions.
Thanks!
Matt
Doing A test run bumping the power on the aluminum quad from 4.2A to 5.6A.
I have 3 of these ready for R4 or R5 LEDs and your choice of modes on the driver.
Specs:
Extremely high quality 100% North American Built Drop-in.
Precision machined to fit genuine surefire and FM26XXX P60 hosts.
Single Li-Ion cell operation for energy density and safety.
LEDs individually current regulated. (Extremely important or LEDs will not receive equal current, other similar drop-ins do not do this)
Integrated thermal shutdown.
Reverse polarity protection. Upside down battery causes no harm.
2KV ESD protection. Resistant to static shock from your fingers.
Low battery warning (drops to low mode and intermittently flashes off quickly).
Mil-Spec Teflon insulated oxygen free silver plated copper conductors.
Silver plated beryllium copper springs with gold plated contacts. (Extremely important, drop-ins using steel springs will fall out of regulation much faster, and may never even reach full current)
Cushioned shock resistant driver.
Modified Khatod Italian made 10 degree FWHM (tested with XPE) beam. Tightest beam possible from P60 multi-LED engine. More common Carclo optics pictured for comparison are 16.4 degree FWHM. (Frosted version pictured)
Fits 6P with ZERO gap.
Available Tint and Flux:
R5 Cool white 6200K
R3 Neutral 5000K
R4 Neutral 4000K
Q5 Warm 3000K
Available Driver Mode Configurations:
5 mode: Low - Med - High - Strobe - SOS
3 mode: Low - Med - High
3 mode: Low - High - Strobe
2 mode: Low - High
1 mode: High
5.6A Aluminum Drop-in
R5 minimum flux calculates to 1780 lumens.
R4 minimum flux calculates to 1665 lumens.
R3 minimum flux calculates to 1560 lumens.
Q5 minimum flux calculates to 1370 lumens.
Thermal Data:
6061 T6 aluminum thermal conductivity: 167 W/m · oK (Heatsink)
Pure aluminum thermal conductivity: 220 W/m · oK (MCPCB)
Bare monolithic aluminum for best conduction of heat into host. Over 30% better heat transfer than brass. MCPCB screw torqued to 32 in-lb. creating a clamping force of over 1000 lbs. Arctic Silver 5 thermal paste applied between MCPCB and heatsink.
Artic Silver 5 thermal paste included for application in host P60 socket.
$190
Warning:
These lights can be dangerous. If left unattended it could get hot enough to cause a failure in the battery, resulting in a possible fire or explosion. Do not point light at eyes or skin. This is a very high power device. Do not run unattended.