Is it difficult to change driver on an XM-L?

I have a few MFront XM-L 3 modes in L2P and L2T's.

I see that ShiningBeam has 2.8A 3 mode drivers for XM-l's

Is that a hard change to make?

I can solder and think I would like the regulated drivers better than the PWM regulated XM-L from Manafront.

Any feedback would be great!

Thanks,

J

Excellent tutorial: http://flashlightwiki.com/DIY_P60

fvdk said:

Excellent tutorial: http://flashlightwiki.com/DIY_P60

Click to expand...

Oh man, that's perfect, thanks!

Do you have the ultrafire 3 modes dropins that are DD? Did you want more of a regulated driver? Those drivers may not fit without some spacer on the positive end of the battery. Do some more research before you buy those drivers, the spring is real short. I personally would stick with the Ultrafires if that's what you have and if you don't, I would check into those instead. Just make sure your batteries are protected and could handle high current i.e. Trustfire flames are awesome! anyways, good luck


Lumens Industry