goldserve
Flashlight Enthusiast
I have a limited number of brand spanking new FLuPIC v2.1 converter boards.
Let's start with the firmware features itself.
FLuPIC v2.1:
-User adjustable LOW level
-User adjustable HIGH level
-Burst level up to 1.2A
-User adjustable strobe frequencies from 4hz to 15hz
-5 user modes available
*Defaults in firmware: Low (3/20), High (15/20), Strobe (10hz), User Mode 1
Please refer below for the userguide:
Board information:
-0.6" (15.2mm) in diameter
-0.068" (1.72mm) board thickness
-0.14" (3.53mm) board thickness including tallest component
-0.26" (6.66mm) in diameter of battery contact pad on the back
-0.06" (1.5mm) in diameter of screw holes
-0.47" (11.91mm) from center to center of screw holes
Battery configurations:
The following combinations will work but not have stressed fully at some configurations.
1 x 4.2V Li-Ion
3 x 1.2V NiMh
4 x 1.2V NIMh
3 x 1.5V Alk
1 x Pila (Volts???)
2 x CR123 (this is absolutely the max! I can install a resistor 1 ohm resistor to ensure 0.4V is dropped)
I am offering boards soldered and the required posts to solder it to the JIL emitter board. Contact me for details. I am selling these kits for $30. I can offer my modding servies for only $40 complete with international shipping included.
Other possible uses is to hook up the converter board and put into cans like the Q3. The possibilities are limitless!
Let's start with the firmware features itself.
FLuPIC v2.1:
-User adjustable LOW level
-User adjustable HIGH level
-Burst level up to 1.2A
-User adjustable strobe frequencies from 4hz to 15hz
-5 user modes available
*Defaults in firmware: Low (3/20), High (15/20), Strobe (10hz), User Mode 1
Please refer below for the userguide:
Board information:
-0.6" (15.2mm) in diameter
-0.068" (1.72mm) board thickness
-0.14" (3.53mm) board thickness including tallest component
-0.26" (6.66mm) in diameter of battery contact pad on the back
-0.06" (1.5mm) in diameter of screw holes
-0.47" (11.91mm) from center to center of screw holes
Battery configurations:
The following combinations will work but not have stressed fully at some configurations.
1 x 4.2V Li-Ion
3 x 1.2V NiMh
4 x 1.2V NIMh
3 x 1.5V Alk
1 x Pila (Volts???)
2 x CR123 (this is absolutely the max! I can install a resistor 1 ohm resistor to ensure 0.4V is dropped)
I am offering boards soldered and the required posts to solder it to the JIL emitter board. Contact me for details. I am selling these kits for $30. I can offer my modding servies for only $40 complete with international shipping included.
Other possible uses is to hook up the converter board and put into cans like the Q3. The possibilities are limitless!