Is this a p60 host?
Ultrafire WF-502B 3W Cree 18650 Flashlight
Thanks Rob
+
Yes, the WF-502B is definitely a P60.
_________________________________
The Romisen RC-G4 is just like the Ultrafire C2, thats not a P60.
Is this a p60 host?
Ultrafire WF-502B 3W Cree 18650 Flashlight
Thanks Rob
Is this a p60 host?
Ultrafire WF-502B 3W Cree 18650 Flashlight
Thanks Rob
Definetely and has a roomy head too that will fit maybe ANY module. (to heat dissipation expenxse). But all of the ones that passed through my hands had switch problems...
These are worth their weight in gold:
http://www.dealextreme.com/details.dx/sku.5632[/quote]
Plus one! An installation tips is needed though. Get a faucet rubber ring. it is 3-4mm thick and about the proper diameter. Enlarge the hole to 9mm with a special hole-cutting punch. (The only thing that works).
In case soemone is that depewrate i can send him some cut by me at no expense,
BTW be careful with the -502 and all the similar flashlights. if you install the switch in the "on" setting.....or you replace the module with switch on and batteries already in the flashlight, there is a good chance you will sort and burn/melt the switch. Do not ask me how I know....
all the best Kostas
The Romisen RC-M4 also takes P60 modules. It is a one-mode 1X18650 or 2X16340 host, but I do not know if it takes protected 18650 cells. I also do not know if it has a retaining ring holding the glass in place. The RC-E4 glass is loose.
I have also found that many P60 modules are tight in the RC-E4 and have to be pushed out from below. Today I inserted a new one-mode MTE Q5 (<$10), and it fits perfectly. The resistor in the switch makes this configuration a two-mode light.
Thoughts about DX sku.903 WF-501B
http://www.dealextreme.com/details.dx/sku.903
Has places for o-rings, yet no o-rings were shipped with the light. So not waterproof at all unless you get o-rings separately.
Very poor machining, bezel was stuck and didnt remove without tools + threads were in bad shape and not oiled -> Now I have very bad scratches in body due to use of tools to open bezel.
Cheap feeling clickie with no momentary option, if you get this light, make sure to buy these too: http://www.dealextreme.com/details.dx/sku.5632
Probably 18650 will fit. Stock 9v lamp bright with 2x RCR123 3,6v
Dx sku .6090 is compatible.
I thought this was going to make a good p60 host but no way. I dont recommend this to anyone. Save some money and get a better host.
Now i'm still looking for a decent moderately priced p60 host, good ideas anyone? Preferably with momentary function and HAIII.