3D Mag85>> What do I have to do to use a Malkoff dropin?

[PoliceScannerMan]

I have a Sweet 3D flamed Maglite that is set up as a Mag85. I would like to use a Malkoff Dropin in this light....

What do I have to do to the light to accomodaste this?

Right now this thing uses the Bi-pin WA1185 bulbs...

Thanks!

 

[PoliceScannerMan]

Do I need to put a stock "driver" back in it?

 

[Bullzeyebill]

I have a 3D set up with a Malkoff Triple, and the principle is probably the same for electrical contact. I would say that you need the stock switch which includes the pedestal. Might be good to buy another 3D.

Bill

 

[bigchelis]

I have a 3D set up with a Malkoff Triple, and the principle is probably the same for electrical contact. I would say that you need the stock switch which includes the pedestal. Might be good to buy another 3D.

Bill

Bill,
How many cells are you running in the Malkoff Tripple?

I have mine running on 4 C NiMH cells (rated up to 5.5v) and I just aquired a IC mag hosts where I run 1 IMR C cell.

Back to the OP...

What Malkoff Drop-in are you going to run?

 

[PoliceScannerMan]

What Malkoff Drop-in are you going to run?

Just the 3D one that runs forever on Alkaline D cells.

I guess my question is, do I need to take out the metal parts, and put the Maglite back to stock config? Or can the dropin use the same bipin holes the WA1185 does?

 

[USM0083]

Just the 3D one that runs forever on Alkaline D cells.

I guess my question is, do I need to take out the metal parts, and put the Maglite back to stock config? Or can the dropin use the same bipin holes the WA1185 does?

Follow Gene's instructions: http://www.malkoffdevices.com/instructions.htm

The dropin screws into the stock bulb tower. You need a reflector without a cam.

 

[Bullzeyebill]

Bill,
How many cells are you running in the Malkoff Tripple?

I have mine running on 4 C NiMH cells (rated up to 5.5v) and I just aquired a IC mag hosts where I run 1 IMR C cell.

Back to the OP...

What Malkoff Drop-in are you going to run?

Re Triple, am using 3D NiMh. Tried 4C's and it gets super hot fast.

Bill