• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired 3XML M*g C & D drop in by Fivemega

Candle Power Forums

Help Support Candle Power:

Thanks for the rapid support.

Yes, I read the directions, and followed them exactly as written.

I also fully removed the head before attempting the install.

I can install the brass nut first, and then the black piece on top.

Is this acceptable?

The brass part does indeed screw onto the switch tower, but only first.

Then I can install the black piece after.

This seems backwards from the photos and directions.
 
Purpose of brass part is to provide negative contact to LED modile and in mean time hold the black positive contact in place. So black part goes into switch tower first and then secured with brass nut.
 
Purpose of brass part is to provide negative contact to LED modile and in mean time hold the black positive contact in place. So black part goes into switch tower first and then secured with brass nut.

That is as I suspected.

Mine, however, does not function in that manner.

However, since the purpose of each piece is to provide an electrical path,
my guess is that the order doesn't matter as long as each piece is snug, correct...?
 
As an Amazon Associate we earn from qualifying purchases. Product prices and availability are accurate as of the date/time indicated and are subject to change.
I see, thanks for the info.

I was hoping perhaps this would work with the adapter you sell.
 
I just paid for

#05 8.4V 3XML kit usd88 - 20% =70.4 + 14 = USD84.4

paypal Unique Transaction ID # 9TN058203N1600211
hwoont64
 
Just sent payment for:

#6 8.4v 3xml kit

$88USD + $8 shipping to USA.

(Unique Transaction ID # 6HN01206R7216742Y)

Jtrucktools34
 
Do you have to buy a separate switch for the 8.4 volt to work in 3 modes? What kind of run time should I expect from the 8.4 with a 6c mag using NiMh?
 
Do you have to buy a separate switch for the 8.4 volt to work in 3 modes? What kind of run time should I expect from the 8.4 with a 6c mag using NiMh?

You don't need to change or modify the stock switch. It will work with single, 3 and 5 mode modules.

Depending on your batteries, you will get up to 5 hours of total run time.
 
Last edited:
3 XML 8.4 volt kit = your 3D incan M*glite from 27 lumens to 2200 lumens.
will fit and work properly on any M*g C or D without letter in the front of the serial number.

Does it really put 2200 lumens? What about a 2D M*g with two protected 18650?
 
Payment sent, (minus the 20% Christmas discount), for #07 8.4 volt 3 XML kit. Paypal transaction #8NW51708GH953311F.
 
:paypal: for
#15 12.6 volt 3 XML kit $89 (AVAILABLE) with international shipping
Thank you!
 
Back
Top