RCatR
Enlightened
I hope this is in the correct category...
I bought a dorcy 1w flashlight and adapted it to hold 2 cr123's, and turned a heatsink assembly that replaces their cheap plastic assembly
my question now is: with a direct 6V what emitter should I use?
i was thinking about the Lux3 UX1N, or the Lux5 WS1X or Lux5 UYAT
from the way i modded it it would be possible to rig up a 3V source, by runnning the cr123's in parallel.
im also taking the 1W Luxeon from the dorcy and popping it (with a heatsink) into a minimag, should i keep the 1W 1ohm resistor i pulled from the dorcy? I dont think that 3v direct from AA's in a minimag would really hurt it at all..
thanks for any advice, in advance
I bought a dorcy 1w flashlight and adapted it to hold 2 cr123's, and turned a heatsink assembly that replaces their cheap plastic assembly
my question now is: with a direct 6V what emitter should I use?
i was thinking about the Lux3 UX1N, or the Lux5 WS1X or Lux5 UYAT
from the way i modded it it would be possible to rig up a 3V source, by runnning the cr123's in parallel.
im also taking the 1W Luxeon from the dorcy and popping it (with a heatsink) into a minimag, should i keep the 1W 1ohm resistor i pulled from the dorcy? I dont think that 3v direct from AA's in a minimag would really hurt it at all..
thanks for any advice, in advance