6V input Driver board with 1000ma+ output?

[richardcpf]

I just fully dissembled my Fenix T1, after the driver board became unstable because of a hard drop.

Now I need a 17-19mm board, which takes 2xCR123 (6V), and have a nice output of 1000ma, or even better 1400ma. It will be used to drive a R2 emitter. Can be single mode or multi, no problems with that.

I looked at DX but all I found was 800ma output or low input voltages. If any one knows any nice board please post it here.

Thanks!

 

[HEY HEY ITS HENDO]

Hey Rick
...... take a steady stroll round here......

............ http://theledguy.chainreactionweb.com/product_info.php?products_id=1205

 

[eprom]

Hi RichardCPF,

If your bugdet is ok, you must use shark buck. If you are looking for a inexpensive solution try to use DX sku.3256, this board gives near 1A @6V input. And has an ~90% efficiency at that level.

EpRoM