3rd_shift
Flashlight Enthusiast
I put together a 4x3 on a copper heatsink last week.
4 TYOHs. /ubbthreads/images/graemlins/mecry.gif
When I fired it up, some of the emitter's temps shot way up indicating that they had not sat all the way down into their mounting pits on the heatsink. /ubbthreads/images/graemlins/ooo.gif
In 60 seconds, some of the emitters were at 170 degreesF while the heatsink was only 110F. /ubbthreads/images/graemlins/confused.gif
I would like to find a safe way to remove, clean up and with a little help from a Dremel, properly remount these emitters. /ubbthreads/images/graemlins/help.gif
4 TYOHs. /ubbthreads/images/graemlins/mecry.gif
When I fired it up, some of the emitter's temps shot way up indicating that they had not sat all the way down into their mounting pits on the heatsink. /ubbthreads/images/graemlins/ooo.gif
In 60 seconds, some of the emitters were at 170 degreesF while the heatsink was only 110F. /ubbthreads/images/graemlins/confused.gif
I would like to find a safe way to remove, clean up and with a little help from a Dremel, properly remount these emitters. /ubbthreads/images/graemlins/help.gif