attowatt
Enlightened
Confused on 3 nuwai Q-III\'s
Ok,
Now I am really confused. I purchased qty 4 of these nuwai q-iii's, sold one and kept 3. I installed the panasonic batts in remaining 3 and noticed that 2 appeared to be white w/ a smidgeon of blue. The last one was definately more white with quite a bit of yellow. However, when I opened them, they are all listed as SX1L./ubbthreads/images/graemlins/thinking.gif
I left them on for sometime and noticed that after about 1 hour , one started to blink approximately: off/3 seconds, then on/2 seconds. The other 2 remained on but were slightly dimmer. this(blinking one) went for about 20 minutes then it stayed on continuously. /ubbthreads/images/graemlins/thinking.gif Other 2 remained constant on, but were getting dimmer. This went for about 1hour 45 minutes and then they all started getting really dim( is this moon mode?).
After they died completely I measured 1.5v, 2.02v, and 2.06 volts.
My questions are these:
1. What is moon mode?
2. How is it that 1 is definately more wht/ylw than the other 2 but have same code?
3. What's with the blinking rate on 1 and then back to steady on rate?( this is the one that measured 1.5 volts.
4. what type of glue can I use to re-seal the head ?, as I will be giving them to nephews after setting up glow powder like this one here.
Any help or ideas is much appreciated, in advance
Jim
Ok,
Now I am really confused. I purchased qty 4 of these nuwai q-iii's, sold one and kept 3. I installed the panasonic batts in remaining 3 and noticed that 2 appeared to be white w/ a smidgeon of blue. The last one was definately more white with quite a bit of yellow. However, when I opened them, they are all listed as SX1L./ubbthreads/images/graemlins/thinking.gif
I left them on for sometime and noticed that after about 1 hour , one started to blink approximately: off/3 seconds, then on/2 seconds. The other 2 remained on but were slightly dimmer. this(blinking one) went for about 20 minutes then it stayed on continuously. /ubbthreads/images/graemlins/thinking.gif Other 2 remained constant on, but were getting dimmer. This went for about 1hour 45 minutes and then they all started getting really dim( is this moon mode?).
After they died completely I measured 1.5v, 2.02v, and 2.06 volts.
My questions are these:
1. What is moon mode?
2. How is it that 1 is definately more wht/ylw than the other 2 but have same code?
3. What's with the blinking rate on 1 and then back to steady on rate?( this is the one that measured 1.5 volts.
4. what type of glue can I use to re-seal the head ?, as I will be giving them to nephews after setting up glow powder like this one here.
Any help or ideas is much appreciated, in advance
Jim