DBS V2 tail cap keeps comming unscrewed on the inside????

[fire-stick]

The last few times I have taken my tail cap off the aluminum metal disk on the inside keeps coming unscrewed.

I tightened it a little with the tip of my knife, but it didn't work so well. Is there a certain tool I should use to tighten it?

After I tighten it will it stop of is there something wrong with it?

Thanks

-Scott

 

[TooManyGizmos]

:naughty:

Don't tighten the end cap so tight ... when you change batteries.

That will help some.


It is a common problem .

 

[FireStik]

You can use a needle nose pliers to tighten that insert - one jaw in each hole.

 

[WadeF]

Don't ruin your knife, do as FireStik said and get some fine needle nose pliers so you can grab both holes and properly tighten it. I don't have any problems with mine coming loss, I tighten it pretty good.

 

[fire-stick]

I don't tighten it hard just kida snug.. alough I will start putting it on a a little softer..

I'll find a real small set of nedle nose pliers and try that... thanks