Endeavour
Flashlight Enthusiast
Hey Folks,
I'm looking into getting some NX-01 optics injection molded or machined out of acrylic or polycarbonate by a local plastics shop, and would like to see what the interest is.
If there's a lot of interest, injection molding is the way to go, if not, likely machining is best.
Regardless, I'd like to get a general idea of how much this would cost so I can get a quote for the best method to make these in.
If you'd be interested in these assuming they're made, please post how many you'd like so I can get a better estimate of the end cost.
Thanks.
-EM
I'm looking into getting some NX-01 optics injection molded or machined out of acrylic or polycarbonate by a local plastics shop, and would like to see what the interest is.
If there's a lot of interest, injection molding is the way to go, if not, likely machining is best.
Regardless, I'd like to get a general idea of how much this would cost so I can get a quote for the best method to make these in.
If you'd be interested in these assuming they're made, please post how many you'd like so I can get a better estimate of the end cost.
Thanks.
-EM