First LED Dive Light Build

[Codiak]

Hmm... Looks like there's not many drivers available for these then. I found a few on that link you sent but they'd been discontinued/no longer found. LEDSupply.com says they don't carry any drivers with that capacity. Or I'm just searching wrong.

No heat sink, it was more of a joke/ease of testing thing than anything. I was tired of testing by holding it by the wires so I just mounted it to a piece of wood to make it easier on me. I'm heading to a local electronics store to poke around for parts/heat sinks then to Home Depot.

Thanks for all the information, again!

Need drivers? Taskled.com

 

[jspeybro]

perhaps this could work:
http://www.intl-outdoor.com/boostbuck-318v-triple-xml-circuit-board-p-542.html
http://www.intl-outdoor.com/xml-multicell-circuit-board-3a-55126v-p-361.html

You can use it with the 3 xml's in series connected and the beginning and the end connected to the driver.
Seems to support also a quite wide voltage range.
or SKU 128269 from DX, but I guess you're not going back there. I have some those here that I don't use, so I could sell it to you if you need it. PM me if interested. I used those already to run 3 XMLs from a 12V NiMh battery but it should work from Li-ions as well.

I searched the driver list with parameters current between 2400 and 3300, and supporting 3 leds in series.