outer limits
Newly Enlightened
- Joined
- Aug 5, 2008
- Messages
- 21
I am after a low current multi mode driver. Max about 350mA, min about 35mA I am currently using a buckpuck 3023 but is there anything cheaper.
? Low current multi mode driver
- Thread starter outer limits
- Start date
Help Support Candle Power Flashlight Forum
Sabrewolf
Flashlight Enthusiast
What batteries are you planning to use?
And where did you get the buckpuck from?
Robert M.
You can buy one of the following & remove two of the AMC7135 regulators to give you arounf 300ma - 350ma on high.
2 mode
5 mode
I'm not sure what the lower levels would be with any regulators removed. There's other from KD & DX that you can do the same too if your into all those modes. I have the two mode one & it works great, it has memory (remembers last level used).
You could also use a 10.5mm flupic. The regulator is rated for 400ma.
I can also offer you a standard size Flupic with the Draco UI & remove one regulator to give you the rated 400ma. Basically the same as the 10.5mm Flupic but in a 0.55" size.
BuckPucks can be purchased from LED Supply
2 mode
5 mode
I'm not sure what the lower levels would be with any regulators removed. There's other from KD & DX that you can do the same too if your into all those modes. I have the two mode one & it works great, it has memory (remembers last level used).
You could also use a 10.5mm flupic. The regulator is rated for 400ma.
I can also offer you a standard size Flupic with the Draco UI & remove one regulator to give you the rated 400ma. Basically the same as the 10.5mm Flupic but in a 0.55" size.
And where did you get the buckpuck from?
Robert M.
BuckPucks can be purchased from LED Supply
