Mag 2C Tri Seoul

[andyz]

Nothing new nowdays it seems but I thought I would add my pics.

Its a Mag 2C using a shark converter, Star Hexa [USXPI] LEDs, Clear Glass Lens, IMS20 Reflectors. I have not added the dimming pot as yet, maybe later when I get my hands on a 20k.

The light is awesome (better than I expected), runs only warm and no drama with the converter as it is sitting on a solid heat sink

 

[Long John]

Congratulations, very nice light with good performance, well done:thumbsup:...:goodjob:

Best regards

____
Tom

 

[X_Marine]

You lucky dog..
I wish I had time to do that to mine.. That just looks like it was meant to be..
I would be curios what your run times are. I'm still a little on the edge as to which way to go as for 1 or 3 emitters.

Really looks nice..

ThanX for sharing..
X..

 

[Weylan]

Very nice! And the nice color on the heatsink is interesting touch.
I have a regular tri LUX and I like that really a lot. I have seen that the tri SEULs are nicer still.

I like how there is a nice compromise including useful spill and throw with the 3 emitters.

 

[waynejitsu]

Nice and clean looking, good job:thumbsup:

 

[ace0001a]

What kind of battery configuration did you use?

 

[andyz]

I used two 18500 Ultrafires, the battery tube is cut from 25mm Heavy Duty PVC Pipe (used here by our electricians for underground wiring).

The pipe fits snug in the mag body with a few layers of masking tape wrapped around it, its not the prettiest set up but works great

 

[Icarus]

Very nice! :goodjob:
How did you prevent the reflectors from turning when tightening the bezel? :thinking:

 

[andyz]

Clean Glass Lense (inside face)
Sit Lense over reflectors.
Place bezel over lense.
Push down tight on glass lense with two fingers (so not to twist).
Screw bezel while holding glass down tight with your fingers.
Clean finger prints off top of glass lense.

It worked well for me

 

[ace0001a]

Yeah, good work man! :thumbsup:

Too bad we couldn't fit 3 27mm reflectors in a Mag head...