Have a old 3d cell maglite (switch is gone), want to run a external switch and battery. So can I just run a positive wire from the brass button on the bulb housing and a wire from the negative spring of end of the flashlight to a simple switch.Guess the question is will it work?
Maglite external switch battery
- Thread starter Chbronco
- Start date
Help Support Candle Power Flashlight Forum
greenpondmike
Flashlight Enthusiast
I would just order a new switch and housing from maglite. As long as it doesn't have any damage from batteries they should send you one for free with the allen wrench. They did for me- didn't even have to send it in. Ask for a supervisor and tell them you're from candlepowerforums.IMHO it would a good ideal to leave a positive review here afterwards.
Last edited:
Think I am going to make it a Frankenstein flashlight. Got a 4-12 volt led comming, two wires from the led out of the head to a 12v off/on switch then to a dc dimmer switch then to a 12volt big rc battery. Any recommendations for a dimmer switch?
alpg88
Flashlight Enthusiast
- Joined
- Apr 19, 2005
- Messages
- 5,660
not really, without the switch there is no negative contact, the set screw inside the switch is what bites into the barrel to provide negative contact to the bulb
Going to do it a little different there is a little brass looking button on the bulb housing that sould be positive, sloder a wire to that and a wire to the side of housing.Then to a off/on switch, 12v big lipo rc battery. Would like to use a adjustable voltage regulator dimmer switch but don't know what to use. Suggestions please?
UH..before you detonate a lipo battery a few feet from you're body...maybe consider just getting another Maglite..just my 2 cents.
Have used RClipos for years .Will have one of those hobbyking lipo battery tester alarms on the battery sould be ok.Its going to be a steam punk ,apocalyptic type flashlight witch will be mostly for show not to see much real use.
Last edited:
