You can become a Supporting Member.
Received a Z41 shroud with the clip today.
I just wanted to verify about how much force is necessary to install these on a G2 tail cap.
It looks like I'm going to have to place a board or something similar over the shroud & then use a hammer to pound it into place (or preferably a rawhide/rubber hammer if I had one handy).
Does that sound about right?
I think you are supposed to place the shroud in a plastic baggie & place it in boiling water for a few minutes so it is easier to put on the light. Once it cools it's on tight!
Thanks FT.
Yes, some tailcaps are a bit larger diameter than others, thus it takes more force to get them on.
Boiling the shroud first will ease installation.