Hi there this is my first post. I am a owner of a machine shop and curious about making a few lights.
To get me started I thought that I would learn to convert an old Pelican M6 to an LED such as the Cree or something. I am not up to date with the new LED flashlights, but have owned a few of the older ones.
I was wanting to see if someone could give me a hand converting this light. Here are some pictures.
This flashlight uses two CR123A's and burns through them in about an hour, so I was hoping to gain run time and output.
Any help would be greatly appreciated.
Thanks
Greebe
To get me started I thought that I would learn to convert an old Pelican M6 to an LED such as the Cree or something. I am not up to date with the new LED flashlights, but have owned a few of the older ones.
I was wanting to see if someone could give me a hand converting this light. Here are some pictures.
This flashlight uses two CR123A's and burns through them in about an hour, so I was hoping to gain run time and output.
Any help would be greatly appreciated.
Thanks
Greebe