Pydpiper
Flashlight Enthusiast
I just went to Home Depot to get a new set of 123's, my one week old G2 was fading a bit it seemed.
I got to my truck and put in the new batteries to check it out, it wasn't fading as much as I thought so I put the original surefires back in.
Once home I pulled out my light (as I do a hundred times a day) and hit the button to see my already lit up wall..
NO LIGHT!
I put the new Duracels in and it works fine.. Was it something I did?
one cell is 2.49v the other is 2.51v is that too low to power this little fella up?
If it is, what do I do with partially depleted cells?
I got to my truck and put in the new batteries to check it out, it wasn't fading as much as I thought so I put the original surefires back in.
Once home I pulled out my light (as I do a hundred times a day) and hit the button to see my already lit up wall..
NO LIGHT!
I put the new Duracels in and it works fine.. Was it something I did?
one cell is 2.49v the other is 2.51v is that too low to power this little fella up?
If it is, what do I do with partially depleted cells?