Finally got around to finishing up my work EDC. Absolutely HATED the clip that came with the Tool. It started out as a black Benchmade deep carry clip from my Mini Bugout, I stripped it so it matched the light better(might even order a Ti one, maybe). Plan was to just tap the lanyard loop and fasten the screws to that but it didn't work out as planned because stupid me had the wrong size tap. 
I ended up just opening the hole a bit and drilling the other side and using nuts to hold it together.
It doesn't tail stand now but this is my work EDC light, tail standing is not in this guy's requirement.
I might just remove the loop on the other side to make it easier to press the button, we'll see.
I ended up just opening the hole a bit and drilling the other side and using nuts to hold it together.
It doesn't tail stand now but this is my work EDC light, tail standing is not in this guy's requirement.
I might just remove the loop on the other side to make it easier to press the button, we'll see.
