Where can you put trits on a P3d?

[Solar Powered Pickle]

I was thinking of placing two or three in the rim of the tail cap clicky furthest away from the two laynyard holes. Then covering them with clear epoxy. I'm hoping they will stay with just the epoxy holding them down since I'm not planning on drilling because I don't have the tools.

Anyone have a better idea?

 

[Solar Powered Pickle]

anyone?

 

[Lumenz]

I put a couple trits on either side of the clicky switch. They are held on with Superglue. They have been holding fine for months. Using epoxy will be much more secure than my Superglue.