Sold/Expired WTB Hard Anodized Sub 2D or Sub 2C Hosts

[skalomax]

Like stated above, looking for any HA Sub 2D or Sub 2C Maglite hosts.

Thank you.

 

[SR.GRINGO]

2D Set @ $175.00 consists of
- new tri-bored 2D M@glites with a HA-III finish by Fivemega
. . . . - tri-bored by Fivemega
. . . . - spring recessed into tailcap
. . . . - HA-III finish, nicely polished
- AWR's Hi-power LDO HotDriver (NOT for 100w applications)
. . . . - consists of AWR's LDO hotdriver
. . . . - Kiu's Hi-Temp Bi-Pin socket
. . . . - all mated/wired to the Mag switch
- assembled modamag 8AA-2D holder

I purchased this from Litho123 with the intentions of modding it but never purchased the correct bulbs to run it. She is a shelf queen….It has two marks that look to be a flaw in the anodizing so being picky I would say 9.5/10
I paid $175…..As I understand it these Hotdrivers are impossible to locate so I will ask what I paid $175.


****the other thing is that I am in Mexico and plan to be up around April 15th so shipping would have to wait until then.

 

[skalomax]

2D Set @ $175.00 consists of
- new tri-bored 2D M@glites with a HA-III finish by Fivemega
. . . . - tri-bored by Fivemega
. . . . - spring recessed into tailcap
. . . . - HA-III finish, nicely polished
- AWR's Hi-power LDO HotDriver (NOT for 100w applications)
. . . . - consists of AWR's LDO hotdriver
. . . . - Kiu's Hi-Temp Bi-Pin socket
. . . . - all mated/wired to the Mag switch
- assembled modamag 8AA-2D holder

I purchased this from Litho123 with the intentions of modding it but never purchased the correct bulbs to run it. She is a shelf queen….It has two marks that look to be a flaw in the anodizing so being picky I would say 9.5/10
I paid $175…..As I understand it these Hotdrivers are impossible to locate so I will ask what I paid $175.


****the other thing is that I am in Mexico and plan to be up around April 15th so shipping would have to wait until then.

Thanks for the offer, but I would rather not wait.
Also, looking for something a bit smaller than a 2D.

Thanks again.:wave:

 

[skalomax]

 

[skalomax]

 

[skalomax]

I would also considered non anodized hosts depending on the configuration.

:thumbsup:

 

[skalomax]

bump

 

[skalomax]

bump

 

[skalomax]

 

[Flash Harry]

I have two of these sitting on a shelf doing nothing, still brand new and unused.

http://candlepowerforums.com/vb/showthread.php?t=164792

I bought three for modding but only ended up using one. I would sell to you for the same price I paid but I'll have to check the shipping price from here to you.

I'm just off to the Post Office now to send something to Norm.

 

[skalomax]

PM sent, thanks!

Do you know if these will fit 4xAA batteries?

:thinking:

 

[Flash Harry]

I just tried to slide in a 4x14670 Fivemega holder and it doesn't fit. I hear there are other after market holders that do fit but I can't think of one right now.

I think there was one sold by the shoppe. Modamag's?