John Frederick
Enlightened
Do any of you Mad Scientists know where I can obtain a tap to cut the threads for a Mini-Mag tail switch? The size needed would also help. Thanks.
Mini-Mag tail cap Tap?
- Thread starter John Frederick
- Start date
Help Support Candle Power Flashlight Forum
DSpeck
Flashlight Enthusiast
Heck, if you can get one for that price, go for it. You'll get a finer finish on a professional one, and likely high-speed steel for that price. I can't provide that material. Thanks for the info, Don.
DSpeck
Flashlight Enthusiast
I could produce one for you. Contact me off-list to work it out.
John,
Not to step on Doug's offer but the tap is a 5/8 x28. I special ordered one from
http://www.rutlandtool.com/
Their part #: 21440297
It was $15.60 + tax and shipping.
- Don
Not to step on Doug's offer but the tap is a 5/8 x28. I special ordered one from
http://www.rutlandtool.com/
Their part #: 21440297
It was $15.60 + tax and shipping.
- Don
John Frederick
Enlightened
Thanks Don.
Doug, I appreciate your offer. I may take you up on it, but first I'm going to try and see what I can do on my own.
Doug, I appreciate your offer. I may take you up on it, but first I'm going to try and see what I can do on my own.
