Olight T10 + Fenix body ???
- Thread starter Kid9P
- Start date
Help Support Candle Power Flashlight Forum
da.gee
Enlightened
- Joined
- Aug 30, 2007
- Messages
- 733
Doesn't fit. They might but the bodies/heads are set up differently. On the Fenix the body is the male and inserts into the head. On the T10 the head is the male and inserts into the body.
ideefixe
Newly Enlightened
I don't have a T10 but rather a T20 and my P2D body screws in. There's a 2-3mm gap at the head so it's not a sealed fit. I was able to change levels. If you were to sand the P2D body down a few mm, it would fit well. Of course, the T20 running on a single RCR123 immediately went into low battery warning on the highest level but ran normally at lower levels. The L2T body fits just as the P2D.
