Fenix P3D tailcap help

Rasto36620 · Dec 18, 2009

Hey guys,

Got a quick question that I hope some one can answer. Today I decided to switch out the rubber tail cap on my Fenix P3D. I thought it just pulled straight out but as I was pulling it it split in half, leaving the plastic switch exposed.

Apparently I have to dissemble the tail cap to put in a new one but I have no idea how to :thinking:. Any help is much appreciated. Thanks! :twothumbs

Rjkpsmith · Dec 19, 2009

Here are a few threads that should help you figure it out... post # 11 of this thread has some really good pictures.
https://www.candlepowerforums.com/posts/2835484

Also this one has some good instructions. https://www.candlepowerforums.com/posts/3147652

If you need to see a video, Fenix has a few out on Youtube showing basic flashlight maintenance, I'm pretty sure that they disassemble the tailcap somewhere in the video. http://www.youtube.com/watch?v=TDxuCB1XCn4 Hope that this helps!

jhc37013 · Dec 20, 2009

And if you need replacement rubber boot you can pick them up here.

http://www.lighthound.com/Fenix-Tailcap-Rubber-Switch-Cover-Orange_p_425.html

Fenix P3D tailcap help

Rasto36620

Newly Enlightened

Rjkpsmith

Newly Enlightened

jhc37013

Flashlight Enthusiast

Similar threads

Latest posts