mudman cj
Flashlight Enthusiast
Please post your interest here for adapters that would convert a Surefire E-series tail to a standard C-series tail thread. This would allow you to use any C tail switch on any E-series body.
The adapter would seal against the O-ring already present on the E tail and would extend a little over the body to allow the tailcap to tighten down to the proper position for electrical contact. The outside of the adapter would have an O-ring to seal against the inside of the tail cap as usual.
This is not meant to be a money maker, but to fill a vacancy in the Lego world. With the rarity of E-series head, C-series bodies, this adapter would provide many possibilities that would otherwise be very difficult to create.
I do not know a price at this time, but based upon the simplicity of the item, they should not be very much. Price will also depend of course upon the amount of interest. Approximately 50 pieces would be required to justify a run. Please post the number of adapters that you would like.
I have already identified a person that could have them designed and manufactured given sufficient interest, but others would be welcome to take that role if desired.
The adapter would seal against the O-ring already present on the E tail and would extend a little over the body to allow the tailcap to tighten down to the proper position for electrical contact. The outside of the adapter would have an O-ring to seal against the inside of the tail cap as usual.
This is not meant to be a money maker, but to fill a vacancy in the Lego world. With the rarity of E-series head, C-series bodies, this adapter would provide many possibilities that would otherwise be very difficult to create.
I do not know a price at this time, but based upon the simplicity of the item, they should not be very much. Price will also depend of course upon the amount of interest. Approximately 50 pieces would be required to justify a run. Please post the number of adapters that you would like.
I have already identified a person that could have them designed and manufactured given sufficient interest, but others would be welcome to take that role if desired.
