Need an o ring for a fenix ld01
- Thread starter american
- Start date
Help Support Candle Power Flashlight Forum
RCS1300
Flashlight Enthusiast
I measured mine and it appears to be a 3/8" ID x 7/16" OD but it might be a metric size close to those dimensions. You should be able to get that from any machine shop that does pneumatic or hydraulic fittings. Any O-ring intended for pneumatic or hydraulic fittings will be compatible with Super Lube.
EDIT: It seems that 3/8" X 7/16" is not a standard size, so it's probably a metric 9.50 ID x 0.80 W
EDIT: It seems that 3/8" X 7/16" is not a standard size, so it's probably a metric 9.50 ID x 0.80 W
Last edited:
I doubt it. You probably need to find a specialty shop.
My first measurement and size estimate was based on overlaying the O-ring on a printed chart; I measured again using my digital calipers (had to find a fresh battery) and I'm revising my guess to metric 9.50 ID x 1.00 W. I suggest trying both sizes and judging by feel.
My first measurement and size estimate was based on overlaying the O-ring on a printed chart; I measured again using my digital calipers (had to find a fresh battery) and I'm revising my guess to metric 9.50 ID x 1.00 W. I suggest trying both sizes and judging by feel.
Similar threads
Latest posts
-
-
-
-
More EV fires after salt water flooding
- Latest: mrfixitman
-
-
-
