Hi all, first post here.
In need your help...
to create a UVC LED flashlight for disinfection purposes eg. bacterial, viral etc.
I found this UVC 4xLED:
https://www.aliexpress.com/item/400...earchweb0_0,searchweb201602_,searchweb201603_
I want to use the above PCB and make my own flashlight, by either:
From the information on the page I can see:
I have not done a flashlight from scratch before (just upgraded my maglight to 3xLEDs).
I need some guidance from the experts in here.
Thank you in advance
In need your help...
to create a UVC LED flashlight for disinfection purposes eg. bacterial, viral etc.
I found this UVC 4xLED:
https://www.aliexpress.com/item/400...earchweb0_0,searchweb201602_,searchweb201603_
I want to use the above PCB and make my own flashlight, by either:
- Buy a host and relevant accessories or
- Buy a ready-made flashlight and swap the PCB
From the information on the page I can see:
- LEDs cover a 7.5x7.5 mm area which should be considered
- PCB is a 20x20mm area which should be considered
- 2x 18650 should be enough based on voltage requirements.
I have not done a flashlight from scratch before (just upgraded my maglight to 3xLEDs).
I need some guidance from the experts in here.
Thank you in advance