js
Flashlight Enthusiast
continued from HDS Systems EDC #17
I'll tell you tomorrow hopefullyAnybody have any preference of the 219A over the 219B led?
HDS EDC Flashlight Instructional Videos by Hogo
1. How to perform a factory reset on your HDS flashlight
2. Enabling Customization in Your HDS Flashlight
3. How to customize brightness settings in your HDS EDC Flashlight
4. Getting into options menu
5. How to set your Turn on Preset on an HDS EDC Flashlight
6. How to set the auto turnoff function on your HDS EDC Flashlight
7. Locator flash
8. How to set your HDS EDC Flashlight into Momentary mode
9. Tailstanding your HDS EDC extended tail flashlight
10. How to get your HDS EDC Flashlight into "Candle Mode"
11. Moving the Rotary Function to mode A, C, or D
12. How to Lego your Clicky into a Rotary
13. How to change the bezel on your HDS EDC flashlight
14. Changing Settings On An HDS EDC Tactical Flashlight
Ok so I can get into customisation mode and if anyone could assist me from here ,
i would like to turn on in tactical mode , double click for emergency strobe, double click again for SOS, and triple click for moonlight low.
from any mode, when I fully press in it will momentary hit high.
Is this possible?.
Thanks lots.
Anyone using the red as a nightlight?
I think my last question slipped by. Is there any way to clean a rotary tail?
I have some grit/sand in it and I hate that feeling and sound.
Oh yea, I also wanted to get in on the first page..haha.
Thanks, DB
Sent from my iPhone using Candlepowerforums
I think my last question slipped by. Is there any way to clean a rotary tail?
I have some grit/sand in it and I hate that feeling and sound.
Oh yea, I also wanted to get in on the first page..haha.
Thanks, DB
Sent from my iPhone using Candlepowerforums
You could do what ShineOnYouCrazDiamond did to his Rotary's tail cap (see HDS Systems EDC #17, p. 33, post #977, second floor, third isle to your right). However I ain't that good (probably break the dang light), so if it was me, I'd send it back to Henry for servicing / cleaning.
Pops
I'm not sure, but maybe rinsing it under running water? The electronics are potted anyway.
Thanks guys, pops like you I'm afraid to even attempt that. However, I HOPE to goodness I don't have to send this light in just to get sand out of the rotary. I have been extremely careful not to set it down or haven't dropped it or anything. As careful as I've been, it still happened and may be a regular occurrence. So, I'd either have to tough it out, or Henry may have my light more than I have my light. Not sure how it got in there, but sand/salt gets in crazy places while on the beach :nasty: ..lol
I may try running water into the rotary. Hope there's a simpler trick than sending it in. May be another point for the clicky team, but I absolutely love the simplicity of the rotary. I'm definitely not looking for reasons to switch to a clicky yet.
Sent from my iPhone using Candlepowerforums