I want to upgrade my Nuwai Q-III with a Cree Q5. I've read that the head unscrews with proper heating to melt the cement. How to properly heat the head without melting the polycarbonate lens? How much heat (hot water, heat gun, gas torch)?
My Q3 is about 1-2 years old. Will a new driver be required? Any good ones with only a high and low mode? I've seen lots of 4 and 5 modes from DealExtreme but they are too complicated to use.
:welcome:
My Q3 is about 1-2 years old. Will a new driver be required? Any good ones with only a high and low mode? I've seen lots of 4 and 5 modes from DealExtreme but they are too complicated to use.
:welcome: