Alternative to replace an M3/L6 body?

[Illum]

I didn't think it was possible that in the several pages of BST that the surefire M3/L6 bodies was such a rarity...and I wish search would stop digging into the archives

Now that the L6 is discontinued its down to the M3/T's to look for to feed my KL6

I figured after the dawn of the 3x18560 body built like an M6 by FM that M series bodies would have a high supply with a low demand for awhile, I guess that was not the case.

I'm not sure if venturing into customs section is a good idea when looking for cheap deals but I don't know what else to do.

Other than leef [nothing wrong with leef but just out of curiosity] is there any alternative bodies compatible with surefire M heads that uses 3x123As out there?

 

[gswitter]

Aren't there a couple of sources (Lumens Factory, Optics Planet, etc) for C2M adapters again?

If so, any C- or E-head 3-cell body is an option as well.

 

[Mikey V]

I didn't think it was possible that in the several pages of BST that the surefire M3/L6 bodies was such a rarity...and I wish search would stop digging into the archives

Now that the L6 is discontinued its down to the M3/T's to look for to feed my KL6

I figured after the dawn of the 3x18560 body built like an M6 by FM that M series bodies would have a high supply with a low demand for awhile, I guess that was not the case.

I'm not sure if venturing into customs section is a good idea when looking for cheap deals but I don't know what else to do.

Other than leef [nothing wrong with leef but just out of curiosity] is there any alternative bodies compatible with surefire M heads that uses 3x123As out there?

I can't even find a Leef or FM 3x123A body out there in M head, C tail. HA III desired. What is up with that?

 

[Illum]

I can't even find a Leef or FM 3x123A body out there in M head, C tail. HA III desired. What is up with that?

well, with the KL6 I have the option of using a 4x123A body...but if I must go that far I might as well look for an M4 body

 

[Paladin]

well, with the KL6 I have the option of using a 4x123A body...but if I must go that far I might as well look for an M4 body

My KL6's fed by 2x18650 only pull about 0.5 amps, and IIRC fed by 4x123's pulled around 0.35 amps. The length of the Leef 2x18650 doesn't bother me. Having a plain body that did not say "Devastator" appealed to me.

Paladin

 

[Illum]

too bad 18650s is fatter than my DSD or else I'd consider that approach