Any way to get a GITD O-Ring into a P3d?

[Solar Powered Pickle]

Is there any of doing this without ruining the light? I read somewhere that the head is sealed via loc-tite.

 

[Jarl]

The head will be very hard to get apart, and probably not worth it. It also voids the warranty.

 

[Sharpy_swe]

My P3D's head is not hard to open, I accidentally unscrewed it so the lens became loose. But it wasn't to complicated to fix it.

 

[TooSharp]

Some patience, couple of strap wrenches and some boiling water will go a long way. Take the batteries out, drop the light in a ziplock bag, I double bag it, hold the head under water for several minutes, remove and try the wrenches. If it only moves a little repeat the heating process. I've unpotted several this way. However I can't find the proper GITD O-Ring. All the ones I've found are too thick and won't allow the bezel to screw down all the way.

Good luck!

 

[Solar Powered Pickle]

... All the ones I've found are too thick and won't allow the bezel to screw down all the way.

Good luck!

Hey thanks for the great info especially about the O-ring size!