goldserve
Flashlight Enthusiast
I'm testing out a design where the FluPIG can be put after a battery input (2V - 10V) and before the input to the converter board or if the converter board can be output disconnected, then after the converter board and before the led.
Basically, theh uP has a wide range voltage regulator so it can take 2V - 10V.
I am using this N-Channel mosfet with low on resistance so power loss is at a very minimal: FDN339AN
I have two pads to put two mosfets incase someone requires really high current draw.
The software still has to be written but a majority of it is the existing FluPIC with the following changes.
1. PWM frequency for user level adjustment is now 480hz. The hand waving trick now longer works
2. Burst will be removed because it no longer makes sense for burst
I need a day or two to collect ideas for some software features to add. Please add your ideas here.
As for beta testers, I need someone that is willing to try this out on many converter boards. PM me your e-mail address and we'll go from there. Thanks!
Basically, theh uP has a wide range voltage regulator so it can take 2V - 10V.
I am using this N-Channel mosfet with low on resistance so power loss is at a very minimal: FDN339AN
I have two pads to put two mosfets incase someone requires really high current draw.
The software still has to be written but a majority of it is the existing FluPIC with the following changes.
1. PWM frequency for user level adjustment is now 480hz. The hand waving trick now longer works
2. Burst will be removed because it no longer makes sense for burst
I need a day or two to collect ideas for some software features to add. Please add your ideas here.
As for beta testers, I need someone that is willing to try this out on many converter boards. PM me your e-mail address and we'll go from there. Thanks!
Last edited: