E-mail to TerraLux

[Frankiarmz]

A couple of weeks ago I sent my TerraLux TS-18 ToolStar LED cluster back to them with a note expressing my disappointment with the defective product, along with another request that they produce a single LED product to fit my 18 volt cordless tool light. Well, I have not heard from them so I just wrote them an e-mail. Currently there must be many thousands of these 18 and higher volt tool lights in use and with no LED conversion available the only choice is to keep replacing standard bulbs. Is it really that difficult a process to design a good LED bulb that can handle 18 plus DC voltage? The actual voltage after charging is just over 20 volts.

 

[Brownstone]

TerraLux usually makes good product, but I've heard nothing but bad about the tool replacement light.

 

[Supernam]

I doubt any company would be interested in making an led module for the "thousands" of those power tool lights. They'd rather cater to the hundreds of thousands (if not in the millions by now) of MagLites that are out there.

 

[mds82]

You can make your own replacements using a BuckPuck 3023 driver and then LED's its a bit more complicated but very worth it!

 

[GLOCK18]

I used a Terr Lux 300 Mag drop in on my 18 volts makita, with a bit of mod.