TranquillityBase
Flashlight Enthusiast
- Joined
- Jun 12, 2005
- Messages
- 3,741
OK...not too exciting, but at least I made everything this time...
Cree XR-E, coupled to a FLuPIC...
In the end, it will have a single cell 123a tube, with a Kroll switch...I've officially given up on finding McClicky switches, and the boot caps, sold at the same location, at the same time...
This is the second, and final version...It's all new, again... The first head was about .115" too long, and I wanted a dedicated cell tube...
This light has a very sticky grip...I went deep with the cut pattern on the tube, and added a few extra rotations to the knurled rings, on the head.
Ti actually knurls very cleanly...no swarf, but it's difficult to get a true pointed knurl pattern...but I prefer this look, and feel, compared to a correct knurl. The corners of each diamond, curl up nicely, and it's just hooky enough, without being so aggressive that it catches on fabric.
TB
Cree XR-E, coupled to a FLuPIC...
In the end, it will have a single cell 123a tube, with a Kroll switch...I've officially given up on finding McClicky switches, and the boot caps, sold at the same location, at the same time...
This is the second, and final version...It's all new, again... The first head was about .115" too long, and I wanted a dedicated cell tube...
This light has a very sticky grip...I went deep with the cut pattern on the tube, and added a few extra rotations to the knurled rings, on the head.
Ti actually knurls very cleanly...no swarf, but it's difficult to get a true pointed knurl pattern...but I prefer this look, and feel, compared to a correct knurl. The corners of each diamond, curl up nicely, and it's just hooky enough, without being so aggressive that it catches on fabric.
TB
Last edited: