To build a 260W UHP short arc spotlight, I need to feed the ballast 300-350V DC.
I am trying to to tap the High DC out from my 12V DC-220V AC power inverter.
rated 350W.
Here is a shot of the Power Inverter opened up & you can see the Capacitor with
450V written on it.
Where do I solder to get the 300-350 DC out of it? Is it possible to tap it from the top side or do I need to take the whole thing out & try to find the 12V DC from the under side?
Some kind of drawing would be greatly appreciated! I am a noob about circuits.
Thanks for helping!
I am trying to to tap the High DC out from my 12V DC-220V AC power inverter.
rated 350W.
Here is a shot of the Power Inverter opened up & you can see the Capacitor with
450V written on it.
Where do I solder to get the 300-350 DC out of it? Is it possible to tap it from the top side or do I need to take the whole thing out & try to find the 12V DC from the under side?
Some kind of drawing would be greatly appreciated! I am a noob about circuits.
Thanks for helping!
Last edited: