MCE and Cutter housing?
- Thread starter MtLuke
- Start date
Help Support Candle Power Flashlight Forum
trout
Enlightened
It would work with 3 MCE but there are no mr11 optics or boards yet
and no one yet knows how it will handle the heat produced by 12 emmitters.
it wont work with one MCE because of the hole down the middle .
now for ideas this is mine .
the mark 5 version has been made while waiting for the bloody thing to be available.
you can see the whole story here at mtbr
http://forums.mtbr.com/showthread.php?t=427669
the light replaces the stem faceplate and will have 3 MCE and it uses the bars for the heatsink (if it works ) if not I have a backup plan.
It is going to be anodised next week ready for when my order from Cutters arrives ( hopefully )
and no one yet knows how it will handle the heat produced by 12 emmitters.
it wont work with one MCE because of the hole down the middle .
now for ideas this is mine .
the mark 5 version has been made while waiting for the bloody thing to be available.
you can see the whole story here at mtbr
http://forums.mtbr.com/showthread.php?t=427669
the light replaces the stem faceplate and will have 3 MCE and it uses the bars for the heatsink (if it works ) if not I have a backup plan.
It is going to be anodised next week ready for when my order from Cutters arrives ( hopefully )
znomit
Enlightened
You might fit three in with polymer optics. Not sure about the height.
Cutter mr11
It has a HUGE amount of finning so should handle the heat.
Cutter mr11
It has a HUGE amount of finning so should handle the heat.
