LivingDaylight
Newly Enlightened
- Joined
- Nov 25, 2011
- Messages
- 70
I modded a 3D Maglite with an XPG on 14mm board, the shiningbeam 1.4Amp driver, and a HAII heat sink.
Should I glue the driver to the back of the heatsink? It seems to me this would be wise to make it move around less, and dissipate the heat. My thermal glue is DX SKU 4579 . It is non-conductive, at least according to my cheap multimeter.
Should I glue the driver to the back of the heatsink? It seems to me this would be wise to make it move around less, and dissipate the heat. My thermal glue is DX SKU 4579 . It is non-conductive, at least according to my cheap multimeter.
Last edited by a moderator: