Timson
Enlightened
I'm trying to solder my new Carley Bi-Pin lamp onto a PCB - but just can't get the solder to take to the pins.
Don't know what the solder mix is specifically....Other than it's the regular stuff you'd use for PCB work.
I've tried scuffing the pin surface with a scalpel and applying flux, but it wont take.
The solder blob is sitting nicely on the PCB board in a nice little Doughnut around the pin
What am I doing wrong
What are the Bi-Pin legs made of
Would a different solder mix do the job or am I
Thanks,
Tim.
(If this is in the wrong section please feel free to move it!)
Don't know what the solder mix is specifically....Other than it's the regular stuff you'd use for PCB work.
I've tried scuffing the pin surface with a scalpel and applying flux, but it wont take.
The solder blob is sitting nicely on the PCB board in a nice little Doughnut around the pin
What am I doing wrong
What are the Bi-Pin legs made of
Would a different solder mix do the job or am I
Thanks,
Tim.
(If this is in the wrong section please feel free to move it!)
Last edited: