Strange problem with my Fenix P3D-CE

[Spypro]

My little P3D is acting strange... here is the story.
I'm using AW RCR123A.
All of a sudden the light stop working.
When I look for the voltage with my multimeter one of the cell is about 2.40v and the other cell is 0.00v !
The light does not flicker at all.

What do you think ? Is it a common problem ?

Big thanks !

Mat

 

[Sgt. LED]

Lemmie know if anything explodes! Really though shouldn't you throw away the flat cell? Or am I remembering it wrong?

 

[leprechaun414]

If you are useing the AW RCR123A then they are probably 3.7 volts each.
You cannot use anything other than 3.0 volt cells for this light. I had the same problem/question and thought something was wrong with my Fenix.
I now use the 3.0 volt RCR123A cells and have no problems.

 

[berto]

You can use 3.7v r123's you just have a bad battery.

 

[leprechaun414]

If the battery you are using is higher than 3.0 volts then the
light will only produce at the highest output setting.

 

[WadeF]

Would a protected cell that has been drained to it's lower limit give a 0.0V reading if the protection circuit isn't allowing any current out? Should he try charging it?

 

[wild68fury]

I use tenergy RCR123A 3.0 volt 900 mAh batteries with no problem in my P3D RB100. They were 4.2 volts each, a day after I took them off the charger. http://www.batteryjunction.com/4parc390reli.html

 

[berto]

this is the p3d all modes will work fine with 2 3.7 volt batteries.

 

[AW]

Spypro,

You have drained your cells down to protection mode. The LVC of the 0.0V cell has tripped and need to be recharged/ reset.

AW

 

[mchlwise]

If the battery you are using is higher than 3.0 volts then the
light will only produce at the highest output setting.

This is true with the P2D, but not the P3D.

With the P3D, the voltage cannot be BELOW 3.5v.

 

[Spypro]

Spypro,

You have drained your cells down to protection mode. The LVC of the 0.0V cell has tripped and need to be recharged/ reset.

AW

I don't know why my P3D does not flicker... is it normal ?
With SF CR123A the P3D is flickering when the cells are low but the RCR123A, no flickering at all.
I don't want to damage my cells.

 

[Nake]

I don't know why my P3D does not flicker... is it normal ?
With SF CR123A the P3D is flickering when the cells are low but the RCR123A, no flickering at all.
I don't want to damage my cells.

The protection circuit on a RCR123 kicks in when there is about 2.7V left in the cell. Times two that is 5.4V. The P3D doesn't start flickering until 4V is detected.