Surefire M6 MB-20 Holder

[Destroid Monster]

Something I have DIY recently out of some PVC plumbing tubes & parts for sharing purposes. I be working on some for 2-3 CR123A only, but would need sometime to look for the parts.

The cap(bottom) cost me about USD$1.50, while the cap(top) screw-type with o-rings cost me about USD$3 each. As for the body, it cost me about USD$0.50/feet...In total, the holder cost me less than USD$5 from the local hardware store. I'm confident that its more than dunk-proof as the pipes & parts are meant for plumbing.

 

[Bravo25]

Hey that MB-20 looks almost familiar.:twothumbs​

 

[Destroid Monster]

Rite on !!!!

 

[StainlessSteel]

Awesome. I like it a LOT. Excellent way to protect a fully loaded MB20. If I had a spare MB20, i would use something similar to that.

now... not to bust your bubble... but if you need to store TWO 123a batteries, the best thing is a Match container. they can be bought for 68 cents... american. it is cheaper to buy one, than build one.

have a good one.

 

[Destroid Monster]

. not to bust your bubble... but if you need to store TWO 123a batteries, the best thing is a Match container..QUOTE]

A good quality match container cannot be found easily here....I saw some around but the quality sucks....seems to me like its China-made. The route to build a PVC one is not good too as the local plumbling stores do not have such small parts.

 

[Tessaiga]

Fellow islander.. where did you buy all the PVC parts from??

 

[Destroid Monster]

Any good hardware shop with plumbing suppiles. Go for 40mm tubes & caps. I've made 3 more...if you are keen, pls PM me for details