Howdy. I've got a UWOJ on the way which I want to transfer into my Orb RAW (it now has a TWOJ in it). If I desolder the leads on the TWOJ, will it lift right up off the old PCB, or is it epoxied on? I have a new PCB coming, too, but would like to use the old one, since it has a two-stage switch.
Also, when I put the UWOJ in, should I epoxy it on, or is the Arctic Alumina thermal compound enough?
Finally, I've been thinking of fixing a supermagnet into the little slot at the back of the case, to use as a quick-release keychain attachment. Will this damage the battery, or intefere with its discharge?
Anyone know?
Thanks for your help: I'm new at this.
JL
Also, when I put the UWOJ in, should I epoxy it on, or is the Arctic Alumina thermal compound enough?
Finally, I've been thinking of fixing a supermagnet into the little slot at the back of the case, to use as a quick-release keychain attachment. Will this damage the battery, or intefere with its discharge?
Anyone know?
Thanks for your help: I'm new at this.
JL
Last edited:
