vorsmann
Newly Enlightened
- Joined
- Jun 22, 2013
- Messages
- 5
Have anyone have any problems with the lantern when switching modes is not activated if unscrew your head and then screwed back working again? Thank you.
Flashlight Fenix LD10 R5
- Thread starter vorsmann
- Start date
Help Support Candle Power Flashlight Forum
The problem you've described hasn't occurred to my LD10 models. I did have a bit of flickering in the light a while back. In my case tightening the switch, cleaning the contacts and relubing the threads made it stop. Perhaps you should do a clean, lube and tightening operation yourself?
Labrador72
Flashlight Enthusiast
Same here, I've had flickering on all my Fenix lights - LD10, LD20, PD30, PD31 - at some point: tightening the retaining ring or cleaning the threads solved it immediately.
AaronG
Enlightened
What seems to be the problem? If it's not going to full brightness the cell is probably run down. Flickering or inconsistent output is usually a loose switch.
vorsmann
Newly Enlightened
- Joined
- Jun 22, 2013
- Messages
- 5
Thank you took your advice everything is working properly.
