Bezel Question

[hoppy1010]

I am thinking of buying a Ti bezel and a ucl lens for my novatac 120P. What is the best way to remove the bezel
any tips would be greatly appreciated.

Thanks In advance Jay

 

[Oddjob]

Mine unscrewed very easliy, there was no loctite or anything. I used the bottom of my mouse pad. Just lay the mouse pad upside down on a table and push the flashlight bezel down on the rubber and unscrew. There are other ways but that's what I have done.

 

[GBone]

Where is the best place to purchase a Ti bezel for the Novatac?

 

[Oddjob]

CPF member RPM has Crenalted and non-crenealated bezels: http://www.candlepowerforums.com/vb/showthread.php?p=2145935#post2145935

Titanium from the Shoppe: http://theledguy.chainreactionweb.com/product_info.php?&products_id=739

Stainless Steel from the fenix-store: https://www.fenix-store.com/index.php?cPath=31_36&osCsid=dcff6d02e54cd55c5f8e3b15041d8634

 

[hoppy1010]

Thanks Oddjob worked like charm:thumbsup:

 

[katx]

Mine unscrewed very easliy, there was no loctite or anything. I used the bottom of my mouse pad. Just lay the mouse pad upside down on a table and push the flashlight bezel down on the rubber and unscrew. There are other ways but that's what I have done.

On a somewhat similar note, I have a Mag 2AA light and tail cap simply would not unscrew. I have used WD40 with no luck. Should I heat it up? Any suggestions?

 

[Oddjob]

I don't know if heat would work. I ran into the same problem once with a minimag and since it was the tailcap that is supposed to screw and unscrew regularly I chalked it up to galling? I got so fed up I actually used two pliers (It was an old beat up MM I was going to throw it away anyways) and I still could not get the tailcap off. Don't know what to suggest.