Help connecting wires to a kaidomain 2-mode driver

[Volny]

I have used this drivers before which I think is really nice: http://www.kaidomain.com/ProductImages.aspx?ProductId=1802

But the latest batch I got was a slightly different driver, with no leads to the led connected.

As they dont look the same as the old ones I am not sure where to solder.

Here is 3 pictures:
http://pici.se/pictures/large/etnaCZlJz.jpg
http://pici.se/pictures/large/kVWxOtyFQ.jpg
http://pici.se/pictures/MpzBaTULA.jpg

Any help?

 

[kramer5150]

http://pici.se/pictures/MpzBaTULA.jpg

Dont you just love how DX and KD make running design changes on these things... LOL.

Just by looking at it,
LED-neg is the ob-round pad on the leg of the far left 7135 driver. The adjacent silkscreeen is labeled with a "-".
LED-pos is the center area with the four thru holes. I would double check this for continuity with the Batt-pos on the other side of the board.

If you are using an XRE, they have built-in reverse polarity protection when used with single cells so in theory there should be no harm in connecting it backwards. I have never tested this however.

These are my best guess, you would be wise to let other members chime in.
Good Luck!!

 

[old4570]

 

[Black Rose]

That circuit looks exactly like the 3-mode one I got from KD not too long ago.

Connections are where Kramer and old4570 indicated.