Looking for Machinist: Turn Optics

[darkzero]

Hello, looking for a machinist who can turn down a few NX-01 optics to fit a FFI.

Thanks

 

[Torque1st]

Possibly take a look at this thread for optic suppliers instead of trying to alter elements?
http://www.candlepowerforums.com/vb/showthread.php?t=189303

 

[PhotonFanatic]

Hello, looking for a machinist who can turn down a few NX-01 optics to fit a FFI.

Thanks

darkzero,

Are you just making the diameter smaller, or adjusting the height?

 

[darkzero]

darkzero,

Are you just making the diameter smaller, or adjusting the height?

No height adjustment. Just need the diameter turned down in two places, the the lip diameter to 17mm & under the the lip to 14.75mm.


FFI NX-05 Lip:

FFI NX-05 Under the Lip:

NX-01 Lip:

NX-01 Under the Lip:

Left to Right: NX-01, FFI Fraen LP, FFI NX-05, NX-01

I would like to get 3 or 4 of them done. I can also send you the FFI Fraen LP as a sample to go off of. Please let me know what you can do.

Thanks

-Will-

:thumbsup:

 

[PhotonFanatic]

Will,

Not that hard to do, after a little jig making work:

And after I cleaned off the cutting fluid:

Send me an e-mail if you want me to do these for you.

 

[darkzero]

Perfect! PM on the way.