So I have all the stuff on the way to build a D sized mag using a SST-90 emitter and the 9a driver sold by DW that can be viewed here...
http://www.candlepowerforums.com/vb...icient-5A-9A-Buck-Converter-for-SST-50-SST-90
and
http://daoriginal.da.funpic.de//data/Buck%20Converter/powerbuck/powerbuck_1_0.pdf
Specs are...
- High efficiency ( 94% - 98%)
- Input voltage range: 6V-22V
- Output current: fixed to 9A
- The input voltage must be at least 2V higher than the output voltage, otherwise output current will get lower.
- 1mm² silicone wires preinstalled
Ok so I am wanting to put this in a preferable 2D mag but the largest I would want is a 3D. What would you guys suggest I use to power this thing? And what would be a guesstimate run time for your suggestions.
Also, what wire do you guys suggest using and can the stock mag switch handle this?
http://www.candlepowerforums.com/vb...icient-5A-9A-Buck-Converter-for-SST-50-SST-90
and
http://daoriginal.da.funpic.de//data/Buck%20Converter/powerbuck/powerbuck_1_0.pdf
Specs are...
- High efficiency ( 94% - 98%)
- Input voltage range: 6V-22V
- Output current: fixed to 9A
- The input voltage must be at least 2V higher than the output voltage, otherwise output current will get lower.
- 1mm² silicone wires preinstalled
Ok so I am wanting to put this in a preferable 2D mag but the largest I would want is a 3D. What would you guys suggest I use to power this thing? And what would be a guesstimate run time for your suggestions.
Also, what wire do you guys suggest using and can the stock mag switch handle this?
Last edited: