zelda
Enlightened
Today I opened a old Cree KX2 head without before heating them up.
(With this method: http://www.candlepowerforums.com/vb...h-glued-threads-HOWTO-without-tools-no-damage)
This came out:
Instead the bezel came off, it only opened a spacer.
Now my questions:
1. To swap the emitter should I heat the head a couple of times and than glue the spacer with locktite and give a second try for opening?
2. How can I access the driver? (The green "ring" in the picture is the PCB.)
(With this method: http://www.candlepowerforums.com/vb...h-glued-threads-HOWTO-without-tools-no-damage)
This came out:
Instead the bezel came off, it only opened a spacer.
Now my questions:
1. To swap the emitter should I heat the head a couple of times and than glue the spacer with locktite and give a second try for opening?
2. How can I access the driver? (The green "ring" in the picture is the PCB.)