P2D reflector

[MarNav1]

Anybody know of a stipled reflector that fits a P2D? Would probably help smooth
out some of the rings in the beam.

 

[Nake]

The Fenix-Store sells one. I have one in my L1D, works good.

 

[MarNav1]

Thanks! I wish I'd of asked earlier, sold my L1d because of the ringy beam.

 

[Blindasabat]

All I see are McGizmo reflectors, did you get one of them or are there others I didn't see? Which one fits? I guess the McR18?

 

[Nake]

Here's a link.

http://fenix-store.com/product_info.php?products_id=224

 

[shakeylegs]

check this link
http://candlepowerforums.com/vb/showthread.php?t=156863

 

[techwg]

How would you replace the reflector? and what benefit do you get extra throw perhaps?

 

[Krit]

I try ti change stock reflector to ROP but I can not find the good one. I gave up and change Cree to Seoul instead. It's a good smooth light from SSC.

thread in non english here.
http://www.trekkingthai.com/board/show.php?Category=trekking&forum=7&No=90988

Thanks to shakeylegs to give me a good link for reflect.

 

[MarNav1]

How would you replace the reflector? and what benefit do you get extra throw perhaps?

The bezel unscrews from the Light engine. It
is glued however so use a couple mouse pads to unscrew them. Remove the glue with a sharp pick (it comes out easily). Then a pair of tweezers or snap
ring pliers to unscrew the reflector. Reassemble with new reflector. It should
remove most of the rings and artifacts in the beam w some loss in throw. I bought stipled reflectors for my D-mini's and WOW what a difference. It's mainly
for those of us who are picky about the beam. 4sevens was nice enough to
help us out so may as well try it.

 

[Gunner12]

Thanks! I wish I'd of asked earlier, sold my L1d because of the ringy beam.

If you want your L1D-CE back(Well, maybe not your L1D-CE but another), just buy the L1D-CE body and it should work since the L1/2D-CE and P2D-CE use the same head.